Skip to main content Skip to search Skip to main navigation

IKA T 65 digital ULTRA-TURRAX disperser, 2 to 50 l, up to 9,500 rpm, 0004234500

Scope of delivery: T 65 digital drive unit with installation tool. The dispersing tool, stand and mains cable are not included and are available separately.

ⓘ  This product description has been translated from German using AI. Despite careful review, we do not guarantee that the translation is error-free; in case of doubt, the German version shall prevail.

Product information "IKA T 65 digital ULTRA-TURRAX disperser, 2 to 50 l, up to 9,500 rpm, 0004234500"

The T 65 digital ULTRA-TURRAX is designed for the transition from the laboratory to the pilot plant, for batches of 2 to 50 litres (H₂O) with a power consumption of 2,600 watts. Unlike the smaller units in the T series, it does not run on a single-phase laboratory power supply, but requires a three-phase connection of 3 x 400 volts, which must be installed by a qualified electrician. Anyone planning this connection should take this into account at the installation stage.

For the transition from laboratory to pilot plant

Three different rotor-stator geometries cover a range of applications from fine dispersion to coarse pre-comminution; a plug-in coupling allows tool changes to be made on the drive without the need for additional tools. Depending on the configuration, the stainless steel dispersing tools can also be used under vacuum and overpressure, provided the relevant accessories are designed for this purpose. The speed range extends from 1,000 to 9,500 rpm with a tolerance of 3 %, displayed via a 7-segment LED display; an error code display assists with troubleshooting during operation.

Performance data for high throughputs

With a power input of 2,600 watts and an output power of 2,200 watts, the T 65 digital significantly outperforms the smaller T 25 and T 50 models; the maximum viscosity is 5,000 mPas. Measuring 300 x 420 x 400 millimetres and weighing 35 kilograms, the unit is designed for a fixed installation rather than portable use; without tools, the noise level is 75 dB(A). The T 65 digital has protection rating IP 54 in accordance with DIN EN 60529; permissible ambient temperatures range from 5 to 40 °C with up to 80 % relative humidity.

Power connection: three-phase and to be carried out only by a qualified electrician

The mains connection is 3 x 400 volts at 50 or 60 hertz; alternatively, a 3 x 230-volt version is available. A 2.5-metre power cable is not included in the scope of delivery and must be ordered separately as an accessory, as must the SI 400 safety limit switch (ID 0003294800) with the matching SI 474 bracket (ID 0003264400). According to the manufacturer, the actual mains connection must be carried out exclusively by a qualified electrician; this is a point that should be taken into account at an early stage when planning the installation, particularly if only a single-phase connection is currently available at the intended location.

Typical applications

  • Pilot plants and technical trials prior to full-scale production
  • Homogenisation of large batches up to 50 litres
  • Applications requiring high power and an increased protection rating
  • Switching between several rotor-stator geometries depending on the formulation

Selection guide: smaller model or laboratory unit

If only a single-phase connection is available or the volume is less than 30 litres, the T 50 digital ULTRA-TURRAX is the more practical choice. For laboratory volumes up to 2 litres, the T 25 digital ULTRA-TURRAX drive unit or the T 25 digital Solution complete set are significantly better suited.

Technical details

Motor power input / output2,600 W / 2,200 W
Processable volume (H₂O)2 to 50 l
Max. viscosity5,000 mPas
Speed range1,000 to 9,500 rpm, continuously variable (tolerance 3 %)
Speed display7-segment LED
Noise level (without tools)75 dB(A)
Process typeBatch
Permissible ambient temperature range / humidity5 to 40 °C / 80 %
IP ratingIP 54 in accordance with DIN EN 60529
Connected load3 x 400 V, 50/60 Hz, 2,600 W (additional voltage variant 3 x 230 V available; connection must be carried out by a qualified electrician)
Dimensions (W x H x D)300 x 420 x 400 mm
Weight35 kg

Scope of delivery

  • T 65 digital ULTRA-TURRAX drive unit
  • Rotor spanner
  • Hook spanner
  • Shaft spanner
  • Cable gland for the switch cable (2 pieces)
  • Angled hex key

The dispersing tool, mains cable (2.5 m) and SI 400 safety limit switch are not included in the scope of delivery and are available separately. The mains connection must only be carried out by a qualified electrician.

Regulatory information

This device is an electrical appliance within the meaning of the German Electrical and Electronic Equipment Act (ElektroG). The WEEE registration number of the manufacturer, IKA, is DE 66784213. Information on the return of old appliances can be found on our Environment and Disposal page.

Warranty and procurement service

The T 65 digital is covered by IKA’s manufacturer’s warranty: 2 years, extended to 3 years if registered at ika.com/register within 90 days of purchase. Our procurement service compiles dispersing tools, stands, safety limit switches and mains cables to suit the existing drive.

Display type: Digital
Max. speed: 9,500 rpm
Power supply: Three-phase current
Supply form: Single unit
Volume range: 2 l - 50 l
Skip product gallery

Matching accessories

Discount Promo In stock
IKA S 65 C - G 65 G Dispergierwerkzeug, Ø 65 mm, für T 65
IKA S 65 C - G 65 G Dispersing Tool, Ø 65 mm, for T 65, 0010001665
Manufacturer number: 0010001665
Sale price: €3,835.20
RRP €4,794.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 C - G 65 M Dispergierwerkzeug, Ø 65 mm, für T 65
IKA S 65 C - G 65 M Dispersing Tool, Ø 65 mm, for T 65, 0010001666
Manufacturer number: 0010001666
Sale price: €4,132.80
RRP €5,166.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 C - G 65 F Dispergierwerkzeug, Ø 65 mm, Keramik, für T 65
IKA S 65 C - G 65 F Dispersing Tool, Ø 65 mm, Ceramic, for T 65, 0010001667
Manufacturer number: 0010001667
Sale price: €4,313.60
RRP €5,392.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KG - HH - G 65 G Dispergierwerkzeug, Ø 65 mm, vakuumgeeignet
IKA S 65 KG - HH - G 65 G Dispersing Tool, Ø 65 mm, Suitable for Vacuum Use, 0010010765
Manufacturer number: 0010010765
Sale price: €4,394.40
RRP €5,493.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KG - HH - G 65 M Dispergierwerkzeug, Ø 65 mm, vakuumgeeignet
IKA S 65 KG - HH - G 65 M Dispersing Tool, Ø 65 mm, Suitable for Use with a Vacuum, 0010010767
Manufacturer number: 0010010767
Sale price: €4,691.20
RRP €5,864.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KG - HH - G 65 F Dispergierwerkzeug, Ø 65 mm, vakuumgeeignet
IKA S 65 KG - HH - G 65 F Dispersing Tool, Ø 65 mm, Suitable for Vacuum Use, 0010010768
Manufacturer number: 0010010768
Sale price: €4,872.80
RRP €6,091.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KD - G 65 G Dispergierwerkzeug, Ø 65 mm, Kugellager, für T 65
IKA S 65 KD - G 65 G Dispersing Tool, Ø 65 mm, Ball Bearings, for T 65, 0010000641
Manufacturer number: 0010000641
Sale price: €3,947.20
RRP €4,934.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KD - G 65 M Dispergierwerkzeug, Ø 65 mm, Kugellager, für T 65
IKA S 65 KD - G 65 M Dispersing Tool, Ø 65 mm, Ball Bearings, for T 65, 0010000642
Manufacturer number: 0010000642
Sale price: €4,244.80
RRP €5,306.00 20% below manufacturer's RRP
Discount Promo In stock
IKA S 65 KD - G 65 F Dispergierwerkzeug, Ø 65 mm, Kugellager, für T 65
IKA S 65 KD - G 65 F Dispersing Tool, Ø 65 mm, Ball Bearings, for T 65, 0010000643
Manufacturer number: 0010000643
Sale price: €4,425.60
RRP €5,532.00 20% below manufacturer's RRP